Material is loaded on rooftop
The "before" look
Another angle...
Another angle on the old roof
Starting to tear it off...
...and the core appears...
Material sorting...
The old insulation
...about 7,000 lbs off the roof
Laying down the insulation
Sweeping the core clean
Scraping off the old insulation
Cutting up the new insulation
That's looking good...
Applying the 2nd layer of insulation
Putting down the Sopra-boards
Increased fire-rating now!
Fastening it down with 2" steel plates
Cutting the Sopra-boards
Wall-to-wall boarding...
Another 3,500 lbs of gravel is going off...
There goes the gravel into the trailer...
The base sheet is being torched on
Starting to "water-tighten" it
Priming up the edges...
Edge-detailing
The new cone arond the soil stack
Applying the primer
A third of the roof is all water-tight!
Installing more Sopra-boards
Everything is prepared...
Cutting the boards
Torching the base sheets
More screws & plates
Perfect fastening!
new curb surrounded by Sopra-boards
Fastening it all...
Flashing around the curb
The curb is prepared...
The last full roll of base sheet
Professional torching
Detail trimming
Almost all watertight
The last detail at 10PM
Our signature
Fastening on the edge flashing
Very solid fastening!
Looking perfect!
Starting with the cap-sheet
Our signature embedded in the roof
Detailing the curb with the cap sheet
Further touches
Experienced hands at work...
The curb is done
Detailing by the A/C
Roof corner detail
Parapet wall finish details
Another parapet wall finish
Another corner detail
The roof has been completed
The soil stack cone is painted
